To install a power supply module:
1.
Remove the face plate or existing power supply by loosening the screws.
2.
Align the new power supply guide with the power supply bay, and
carefully seat the module. (Do not force the power supply. You can finish
seating it when you tighten the face plate screws in Step 3.
3.
Secure the power supply module with one of the screws removed in Step
1. Be careful not to over-tighten the screw.
To remove a module already installed in a iBG3026:
1.
Remove the power supply face plate screw.
2.
Grasp the edges of the power supply and pull it straight out.
3.
Replace the empty power supply bay with another power supply or with
a black face plate.
© SAMSUNG Electronics Co., Ltd.
Figure 5.4 Installing a Power Supply
Ubigate iBG3026 Installation Manual/Ed.01
81