CHAPTER 4. Module and Internal Option Card Installation
Installing ESG-8/ESF-10 Module
To add a ESG-8/ESF-10 module to the iBG3026 chassis:
1.
Remove its blank module panel (or if the slot is occupied, remove the
module) by loosening the two retainer screws.
Figure 4.58 Preparing a ESG-8/ESF-10 Module slot for Module insertion
2.
Align the new module's retainer screws with the screw holes on the slot
bay and carefully seat the module.
3.
Tighten the retaining screws to fully seat the module.
To remove a ESG-8/ESF-10 module already installed in the iBG3026:
1.
Loosen the two retainer screws.
2.
Pull the module straight out of the module bay.
76
Figure 4.59 Aligning the new Network Module
© SAMSUNG Electronics Co., Ltd.