Table of Contents
Advertisement
Installing Mini Modules
To add a mini module to the iBG3026 chassis:
1.
Locate the slot into which you plan to install the module and remove its
blank module panel (or if the slot is occupied, remove the module) by
loosening the two retainer screws.
2.
Align the new module's retainer screws with the screw holes on the slot
bay and carefully seat the mini module.
3.
Tighten the retaining screws to fully seat the module.
© SAMSUNG Electronics Co., Ltd.
Figure 4.54 Preparing a Mini Module slot for module insertion
Figure 4.55 Aligning the new Mini Module
Ubigate iBG3026 Installation Manual/Ed.01
73
Advertisement
Table of Contents
