Two-Sided Copying With Optional Duplex Module - Sharp SF-2540 Operation Manual

Two-sided copying with optional duplex module

Two-sided copies can be made by pressing the ORIGINAL TO
COPY key when an optional duplex module is installed.
PRE-COUNT
ORIGINALS
COPY RATIO
1 0 0 %
EXPOSURE
AUTO
EXPOSURE LIGHT
AUTO
MANUAL
PHOTO
1
2
4 5
8
7
AUDIT CLEAR
0 C
START
9
Downloaded From ManualsPrinter.com Manuals
1
2
ORIGINAL TO COPY
(ORIGINALS)
EVEN NUMBER
ODD NUMBER
3
ORIGINAL
A4
AUTO PAPER
SELECT
DUPLEX
1. A4
DARK TRAY SELECT
4
3
START
6
5
9
6
Place the first original face down on the document
glass and close the document cover.
Press the ORIGINAL TO COPY key to select EVEN
NUMBER.
ODD NUMBER copying is only possible when copying from an
optional reversing automatic document feeder (RADF). (See
page 50 for details.)
Ensure that the desired paper tray is selected.
Paper sizes that can be used in the duplex mode are A5, A4,
A4R, B4, and A3 (8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 14", and
11" x 17").
In some regions, 216 mm x 330 mm (8-1/2" x 13") size can be
used additionally.
Enter the number of copies.
The maximum number of copies in the duplex mode is 50 for
A5, A4, and A4R (8-1/2" x 11" and 8-1/2" x 11"R), and 30 for
the other paper sizes.
Press the START key.
Place the second original and press the START key
again to copy onto the other side.
To stop a copy run during duplex copying, press the clear
( ) key. To resume copying, press the START key. To
cancel copying, press the CLEAR ALL (
manually remove any copies remaining in the duplex module
following the procedure for removing misfed paper from the
duplex module. (See page 35.)
To cancel the duplex mode, press the ORIGINAL TO COPY
key until the indicators in the ORIGINAL TO COPY section all
go out.
NORMAL COPYING
) key and
9