Erase - Sharp SF-2540 Operation Manual

ERASE

This copier has an edge erase mode and a centre erase mode.
Edge erase can be used to eliminate shadow lines around the
edges of copies caused when thick paper or a book is used as an
original.
Centre erase can be used to eliminate the shadow produced by
the bindings of bound documents.
KEY OPERATOR
changed. See page 89. The initial setting of the erase feature can also
be changed. See page 91.
A
A B
COVERS
R ORIGINAL TO COPY
Downloaded From ManualsPrinter.com Manuals
The width for edge erase and centre erase can be
A
A B
ERASE MARGIN
SHIFT
AU
Edge erase
Centre erase
Place the original face down on the document glass
1
and close the document cover.
If an optional reversing automatic document feeder is installed,
you can place the originals face up in the document feeder tray.
NOTE:
When the optional document feeder is used, the width for edge
erase and centre erase will vary with the copy ratio. However,
when the document glass is used, the width will be constant.
2 Press the ERASE key.
The following message will appear for several seconds.
ERASE
"EDGE ERASE", "CENTRE ERASE", or both are highlighted
depending on the setting made using key operator program
P43.
Then the message will change to the following.
READY TO COPY.
SPECIAL MODE SELECTED.
TO CHANGE: PRESS
TO CHANGE: PRESS
EDGE ERASE
CENTER ERASE
KEY.
15