Sharp SF-2540 Operation Manual page 84

KEY OPERATOR PROGRAMS
P10 Auditing Mode
Program P10 is used to enable or disable the basic auditing mode.
When disabled, the message in the display will be "READY TO
COPY." Access to copying is open to any operator.
When enabled, the message in the display will be "ENTER YOUR
ACCOUNT NUMBER. -----". Copying in this state is limited to
operators with an assigned 5-digit account number.
A maximum of 50, 5-digit account numbers can be assigned. Use
key operator program P14 to assign account numbers.
When P10 is entered, the following message will appear.
P11 Number of Copies per Account
Program P11 is used to display the total number of copies made
against each account number.
A3 (11" x 17") copies are counted as two copies. Covers are counted
as one copy.
When P11 is entered, the following message will appear.
P13 Resetting Account
Program P13 is used to reset all audit accounts or to selectively
reset individual accounts.
When P13 is entered, the following message will appear.
82
Downloaded From ManualsPrinter.com Manuals
P10: AUDITING MODE.
1.ENABLE
To enable the auditing mode, press key 1.
To disable the auditing mode, press key 2.
P11: NUMBER OF COPIES PER ACCOUNT.
INPUT ACCOUNT NUMBER TO BE DISPLAYED
AND PRESS THE START KEY.
ACCOUNT NUMBER
–––––
1. Input the account number and press the START key.
The number of copies made will be displayed.
2. Continue with step 1 for other account numbers.
Press the SCROLL DISPLAY key to advance through
the accounts.
Press the PROGRAM key to exit the program.
P13: RESETTING ACCOUNT.
1.ALL ACCOUNTS
2.DISABLE
NUMBER OF COPIES MADE
–––––––
2.SINGLE ACCOUNT