Sharp SF-2540 Operation Manual page 94

KEY OPERATOR PROGRAMS
P45 Message Time Setting
Program P45 is used to adjust the length of time that messages are
displayed in the range of 1 to 12 seconds in 1 second increments.
When P45 is entered, the following message will appear.
P46 Require Key Operator Code
Program P46 is used to prevent the copier from being started by
people other than the key operator. If this program is set, the
message "ENTER KEY OPERATOR CODE." will appear each time
the power switch is turned to the "ON" position.
When P46 is entered, the following message will appear.
P47 Stream Feeding Mode
Program P47 is used to enable the stream feeding mode of an
optional document feeder. When the stream feeding mode is
enabled, additional originals which are set in the document feeder
tray within 5 seconds after the previous original was fed will be fed
and copied automatically.
When P47 is entered, the following message will appear.
92
Downloaded From ManualsPrinter.com Manuals
P45: MESSAGE TIME SETTING.
SET THE TIME FOR MESSAGES
(1 TO 12 SECONDS). PRESS THE START
KEY AFTER ENTRY.
Set the time using the 10-key pad and press the START
key.
P46: REQUIRE KEY OPERATOR CODE.
1.YES
To require key operator code entry for access to the
copier, press key 1.
To enable access to the copier without key operator code
entry, press key 2.
P47: STREAM FEEDING MODE (DOCUMENT
FEEDER).
1.YES
To enable the stream feeding mode, press key 1.
To disable the stream feeding mode, press key 2.
––
2.NO
2.NO