Job Memory - Sharp SF-2540 Operation Manual

JOB MEMORY

Frequently used job programs can be stored in one of nine storage
registers. This is convenient for quick job recall without losing time
manually reprogramming each aspect of the job.
Settings for the following functions can be stored in job memory:
original to copy mode, reduction/enlargement/zoom, auto image,
same-size copying, exposure adjustments, erase, margin shift,
dual page copying, covers (only if an optional reversing automatic
document feeder is installed), tray select, and sort or staple sort
mode (only if an optional sorter or staple sorter is installed).
KEY OPERATOR
prohibited. See page 94.
PROGRAM
INTERRUPT
4
7
AUDIT CLEAR
0
1
4
7
AUDIT CLEAR
0
START
9
20
Downloaded From ManualsPrinter.com Manuals
Job memory replacement/deletion can be
1
2
6
5
S
8 9
C
3
2 3
5 6
S
8 9
4
C
5
6
Storing a job program
Press the PROGRAM key.
The following message will appear.
TO RECALL A PROGRAM, PRESS PROGRAM
NUMBER: 1, 2, 3, 4, 5, 6, –, –, –
TO STORE OR DELETE PROGRAMS, PRESS 0.
The numbers which appear in the display are program
numbers which have been used. The dashes in the display
show unused program numbers.
Press the 0 key.
The following message will appear.
USE 10–KEY PAD TO SELECT MODE.
1.STORE
To cancel the job memory mode, press the CLEAR ALL
( ) key.
Press key 1 on the 10-key pad.
The following message will appear.
TO STORE : PRESS ANY KEY FROM 1 TO 9.
THEN MAKE COPIER SELECTIONS AND PRESS
THE START KEY.
Select a program number from 1 to 9 using the 10-key
pad.
If a program number which has been used is entered, the
existing stored program will be replaced by the new program
when the START key is pressed.
Make all copier selections to be stored.
Press the START key to complete the storage.
2.DELETE