Sharp SF-2540 Operation Manual page 93

P31 Preheat Mode Setting
Program P31 is used to set the time that elapses before the copier
enters the preheat mode after copying is completed. The interval can
be set between 1 and 240 minutes in 1 minute increments.
When P31 is entered, the following message will appear.
P42 Right/Left Shift Direction Selection
This program is used to determine if shift direction change is to be
allowed when the SCROLL DISPLAY key is pressed.
When P42 is entered, the following message will appear.
P43 Erase Mode Initial Setting
This program is used to select the erase mode's initial setting.
When P43 is entered, the following message will appear.
Downloaded From ManualsPrinter.com Manuals
KEY OPERATOR PROGRAMS
P31: PREHEAT MODE SETTING.
SET THE TIME FOR PREHEAT MODE.
PRESS THE START KEY AFTER ENTRY.
(1 TO 240 MIN., 1 MIN INCREMENTS)
1. Set the desired time interval using the 10-key pad.
2. Press the START key.
P42: RIGHT/LEFT SHIFT DIRECTION
SELECTION.
1.ENABLE
To enable shift direction change, press key 1.
To disable shift direction change, press key 2.
P43: ERASE MODE INITIAL SETTING.
1.EDGE 2.CENTER
Select the desired erase mode using the 10-key pad.
–––
2.DISABLE
3.EDGE+CENTER
91