Table of Contents
Advertisement
INSTALLATION REQUIREMENTS
To ensure safety and proper machine performance, please note the
following before initial installation and whenever the machine is to be
relocated.
1.
The copier should be installed near an accessible power outlet
for easy connection.
2.
Be sure to connect the power cord only to a power outlet that
meets the specified voltage and current requirements.
Also make certain the outlet is properly grounded.
For this copier's power supply requirements, see the name
plate located on the right hand side at the rear bottom corner
of the copier.
3.
Do not install the machine where it is:
damp or humid,
exposed to direct sunlight,
extremely dusty,
poorly ventilated,
subject to extreme temperature or humidity changes (e.g.,
near an air conditioner or heater).
4.
Ensure that the area chosen for the machine location is level.
5.
Be sure to allow the required space around the machine for
servicing and proper ventilation.
CAUTIONS
1.
Do not touch the photoconductive drum. Scratches or smudges
on the drum will cause dirty copies.
2.
The fusing unit is extremely hot. Exercise care in this area.
3.
Installation adjusters are provided on the optional stand/3000-
sheet paper drawer or stand/500-sheet paper drawer.
When moving the machine with the optional stand/3000-sheet
paper drawer or stand/500-sheet paper drawer, be sure to raise
the installation adjusters. After moving the machine, lower the
installation adjusters until they reach the floor to lock the
machine in place.
Downloaded From ManualsPrinter.com Manuals
30 cm
(11-13/16")
60 cm
(23-5/8")
60 cm
(23-5/8")
Fusing unit
Photoconductive
drum
Lock
Adjuster
30 cm
(11-13/16")
Release
3
Advertisement
Chapters
Table of Contents
