Sharp SF-2540 Operation Manual page 53

SORTER
SORT
STAPLE
SORT
GROUP
1 2
4 5
7 8
AUDIT CLEAR
0 C
PRE-COUNT
ORIGINALS
Downloaded From ManualsPrinter.com Manuals
2
AUTO
ORIGINAL TO COPY
IMAGE
(ORIGINALS)
EVEN NUMBER
ZOOM
ODD NUMBER
100%
PRE-COUNT
ORIGINALS
3
3
START
6
9
4
1
2
ORIGINAL TO COPY
(ORIGINALS)
EVEN NUMBER
ODD NUMBER
Ensure that the 1-sided to 1-sided copying mode is
selected in the ORIGINAL TO COPY section of the
operation panel.
When no indicator in the ORIGINAL TO COPY section is lit,
the 1-sided to 1-sided copying mode is selected.
Use the 10-key pad to enter the desired number of
copies.
The number will be shown in the copy quantity display.
Use the clear (
been made.
Press the START key.
To cancel a copy run, press the CLEAR ALL (
Copying will stop and the RADF will output any originals which
have been fed. Also, the number in the copy quantity display
will be reset to 0.
2-sided copies from 1-sided originals
An optional duplex module must be installed for 2-sided copying.
Adjust the original guides to the size of the originals
and set the originals face up in the document feeder
tray.
If the number of originals is known, use the ORIGINAL
TO COPY key to select EVEN NUMBER or ODD
NUMBER in the ORIGINAL TO COPY section of the
operation panel, then proceed to step 3. If the number
of originals is not known, select PRE-COUNT
ORIGINALS for an automatic count by the RADF and
press the START key.
The following message will appear.
THE NUMBER OF ORIGINALS IS --.
When the count is complete and the number is known, replace
the originals in the document feeder tray and select EVEN
NUMBER or ODD NUMBER as above.
RADF (SF-A58)
) key to cancel an entry if a mistake has
) key.
51