Interrupting A Copy Run - Sharp SF-2540 Operation Manual

INTERRUPTING A COPY RUN

INTERRUPT can be used to temporarily stop a long copy run so that
another job can be run.
Reduction/enlargement/zoom, exposure adjustments, dual page
copying, erase, and margin shift can be selected during interrupt
copying.
Duplex copying, sort, group, staple sort, and covers cannot be
selected during interrupt copying. Also job program recall cannot
be selected.
INTERRUPT will not function during duplex copying, when the
covers feature is selected, or when an optional card counter (SF-
EA11) or auditor (SF-EA12) is used and the copier has been
programmed in the auditing mode.
START
9
22
Downloaded From ManualsPrinter.com Manuals
1
PROGRAM
INTERRUPT
2
3
4
5
PROGRAM
INTERRUPT
6
Press the INTERRUPT key.
When an optional reversing automatic document feeder is
being used, the copier will stop after completing the copying of
the originals which have been fed into the document feeder.
If this copier has been programmed in the auditing mode, the
account number entry message will appear. Enter your
account number using the 10-key pad. The number of copies
of the interrupt copying will be accumulated against this
account number.
When the copier stops, remove the original(s) and
place the original for interrupt copying on the
document glass. Close the document cover.
If an optional reversing automatic document feeder is installed,
you can place the originals face up in the document feeder
tray.
Select the desired available copier functions.
Press the START key.
When the interrupt copy run is complete, press the
INTERRUPT key again to cancel the mode and remove
the original(s) used for interrupt copying.
The copier will reset itself to the functions which were in use
before the INTERRUPT key was first pressed.
Replace the original(s) for the interrupted job and
press the START key to resume copying.