Printer Setup Menu - Epson SC-F9200 series User Manual

SC-F9200 Series User's Guide
Item
Roll Type
Tension Measurement
Feeding Tension
Auto
Manual
Take-up Tension
Auto
Manual
Prevent Sticking
Restore Settings
Print Media List
Parameter
Print

Printer Setup Menu

is the default setting.
Using the Control Panel Menu
Parameter Explanation
Printable Side
Choose Printable Side Out or Printable Side In according to how the
Out media is rolled.
Printable Side
In
Periodically The tension is measured and adjusted automatically to maintain the
correct tension for the media being printer.
Every Page
Periodically is recommended in most circumstances.
Select Every Page for more precise tensioning, but note that print times
will increase.
-
The default setting of Auto is recommended in most situations. If creases
appear in the media during printing, we recommend using Manual and
0 to 40
setting the value to higher than Lv32.
When banding (horizontal banding, tint unevenness, or stripes) occurs in
printing results, we recommend using Manual and setting the value to
lower than Lv32.
When Media Size Check is set to Off, set Manual, and then set Feeding
Tension to a recommended value that complies with the width of the
loaded media. For details, see:
"Feeding Tension" on page 46
U
- The default setting of Auto is recommended in most situations. If media
wrinkles when printing, or white banding (white or light lines) appears in
1 to 9
the print results, we recommend using Manual and setting the value to
lower than Lv7. Make the same settings if ink adheres to the back of the
take-up roll. If thick media cannot be wound correctly, we recommend
using Manual and setting the value to higher than Lv7.
On Select whether to enable (On) or disable (Off) operations to prevent
media from sticking when the printer is turned on or when printing starts.
Off
Since operations take longer when On is selected, we recommend setting
this to Off. Depending on the media type, it may easily adhere to the
platen. If operations are performed while the media is on the platen, and
the media is not fed correctly causing a jam, set On.
Yes If Yes is selected, the content of configured RIP Settings are returned to the
default settings.
No
Explanation
Print the contents of media setting banks 1 to 30.
96