Epson SC-F9200 series User Manual page 47

SC-F9200 Series User's Guide
Media width
36 in
24 in
If you have previously performed Feed Adjustment, you
will need to perform it again after adjusting Feeding
Tension.
"Feed Adjustment" on page 44
U
A
Use the d/u buttons to select Feeding Tension
and press the Z button.
B
Use the d/u buttons to select the item you want
to change.
Selecting Auto
(1) Select Auto and press the Z button.
(2) Confirm that the checkbox has been selected
and press the Z button.
(3) Press the y button to return to the customize
settings menu.
Selecting Manual
(1) Select Manual and press the Z button.
(2) Use the d/u buttons to set the recommended
value.
(3) After finishing the configuration, press the Z
button.
(4) Press the y button twice to return to the
customize settings menu.
Take-up Tension
Take-up Tension has 2 settings: Auto and Manual.
The default setting of Auto is recommended in most
situations. If media wrinkles when printing, or white
banding (white or light lines) appears in the print
results, we recommend using Manual and setting the
value to lower than Lv7. Make the same settings if ink
adheres to the back of the take-up roll. If thick media
cannot be wound correctly, we recommend using
Manual and setting the value to higher than Lv7.
Basic Operations
Feeding Tension value
Lv18
Lv12
If you have previously performed Feed Adjustment, you
will need to perform it again after adjusting Take-up
Tension.
"Feed Adjustment" on page 44
U
A
Use the d/u buttons to select Take-up Tension
and press the Z button.
B
Use the d/u buttons to select the item you want
to change.
Selecting Auto
(1) Select Auto and press the Z button.
(2) Confirm that the checkbox has been selected
and press the Z button.
(3) Press the y button to return to the customize
settings menu.
Selecting Manual
(1) Select Manual and press the Z button.
(2) Use the d/u buttons to set the recommended
value.
(3) After finishing the configuration, press the Z
button.
(4) Press the y button twice to return to the
customize settings menu.
Feed Speed
The default setting is Lv2. The manufacturer default set
value is recommended in most circumstances. Set Lv1 if
thin media is creased, torn, sticks together, or horizontal
lines appear. To increase the printing speed, set Lv2.
Note that the speed does not change when a large
number (of passes) was selected.
A
Use the d/u buttons to select Feed Speed and
press the Z button.
B
Use the d/u buttons to select the desired setting
and press the Z button.
C
After finishing the configuration, press the Z
button.
47