The Maintenance Menu - Epson SC-F9200 series User Manual

SC-F9200 Series User's Guide
Item
Light
Medium
Heavy
Cleaning Cycle
Heat Off Timer
Restore Settings

The Maintenance Menu

The Maintenance menu can be accessed directly by pressing the # button.
Item
Nozzle Check
Print At Right
Print At Center
Print At Left
Cleaning
Using the Control Panel Menu
Parameter Explanation
Off, 1 to 240 hours
Select the frequency - never (Off) or after 1 to 240 hours - and strength
with which the printer performs head cleaning. Periodical Cleaning will
not be performed while Off is selected. If a value between 1 and 240 hours
is selected, auto head cleaning will be performed after the specified
number of hours. If printing is in progress when the specified time has
elapsed, Periodical Cleaning will only be performed after printing is
complete or the printer is reactivated.
The following reset the timer:
❏
Choosing a setting time for this item.
❏
When head cleaning was performed using All Nozzles at a strength
that is the same as or higher than the setting selected for this setting.
Note that even when Off is selected for Periodical Cleaning, the printer will
automatically clean the print head at a fixed interval after printing to keep
the nozzle from clogging.
Off Select the frequency with which the printer performs auto head cleaning:
never (Off) or once every 1 to 10 pages. The Cleaning Cycle will not be
1 to 10 pages
performed while Off is selected. Select 1 to 10 to perform head cleaning
before the specified number of pages is printed.
15 to 240 minutes You can turn off the after heater automatically when no errors are
detected and no print jobs are in progress. This option is used to choose
the interval before the after heater turns off automatically.
The printer will enter sleep mode when the Heat Off Timer expires. In sleep
mode, the control panel turns off and the internal motors and other
components consume less power.
To reactivate the control panel display, press any button in the control
panel except the P button. The control panel display will however turn off
again if no operations are performed for another 30 seconds under these
conditions. The printer and heaters are only fully reactivated when a print
job is received, the media loading lever is used, or another operation
involving printer hardware is performed.
Yes Select Yes to restore all items in the Printer Setup menu to their default
settings.
No
Parameter Explanation
Print A nozzle pattern will be printed. Inspect the pattern visually and perform
head cleaning if you detect faint or missing colors.
"Checking for clogged nozzles" on page 82
U
The menu displayed in the setting items depends on the Media Size Check
setting and the width of the loaded media.
98