Epson SC-F9200 series User Manual page 68

SC-F9200 Series User's Guide
c
Important:
This printer has a remaining ink warning system.
Use the following procedure for replacement and
ink refills to replace the chip unit and refill the ink
correctly.
This system does not directly detect the amount of
ink remaining in the ink tank. Instead, the amount
of ink remaining is estimated based on the ink usage
conditions and displayed as a message. To
maintain the accuracy of this system, you must
replace the chip unit and refill the ink as soon as
possible once the remaining ink is 70 mm or less
from the bottom of the ink tank.
Procedure for Replacement and Ink
Refills
The refill method differs depending on the type of ink.
Use the refill method that matches the type of ink.
Read the Safety Data Sheet before performing the
procedure.
You can download it at your local Epson Web site.
Maintenance
Caution:
❏ Store ink packs in a location out of reach of
children.
❏ During maintenance, wear protective clothing,
including protective eyewear, gloves, and a
mask.
Should ink contact your skin or enter your eyes
or mouth, take the following actions:
❏ If fluid adheres to your skin, wash it off
using large volumes of soapy water.
Consult a physician if the skin appears
irritated or is discolored.
❏ If fluid enters your eyes, rinse immediately
with water. Failure to observe this
precaution could result in bloodshot eyes or
mild inflammation. If problems persist,
consult with a physician.
❏ If fluid enters your mouth, consult with a
physician as soon as possible.
❏ If swallowed, do not induce vomiting.
Consult with a physician as soon as
possible. If vomiting is induced, vomited
material may enter the windpipe, which is
dangerous.
❏ Note the following points when refilling ink.
❏ Gently tear off the ink pack spout opening.
If you cut the nozzle too quickly, ink may
splatter.
❏ Do not squeeze open ink packs. Ink may
spill.
❏ Gently tilt the ink pack when pouring ink
into the ink tank.
68