Epson SC-F9200 series User Manual page 31

SC-F9200 Series User's Guide
Confirm that the media was fed straight with the
media straight and taut.
Note:
We recommend using the r button on the control
panel to set Media Suction to 2. The media is
rewound straight.
V
Open the front cover.
W
Lower the media loading lever to hold the media
in place.
X
Position the media holding plates.
(1) While holding the tabs of the media holding
plates on both sides, move the plate to the edge
of the media.
Basic Operations
(2) Adjust so that the edge of the media is aligned
to the center of the round holes in the media
holding plates.
c
Important:
❏ Do not use the media holding plates with
media that is more than 0.4 mm thick. The
media holding plates could touch and
damage the print head.
❏ Always position the plates so that the edges
of the media are at the centers of the round
holes. Incorrect positioning causes
banding (horizontal banding, tint
unevenness, or stripes) during printing.
❏ Move the media holding plates to the left
and right edges of the platen when they are
not in use.
❏ Do not use the media holding plates if the
sides of the printed media are smudged or
torn.
31