Media - Epson SC-F9200 series User Manual

SC-F9200 Series User's Guide
❏
When RIP Settings is selected
Slow the feed speed of the software RIP.
❏
When 1 to 30 (media setting banks) is selected
Set Feed Speed in the setup menu to Lv1.
B
Check the attachment of the media holding
plates
If a media holding plate is not installed correctly,
media feeding may be disturbed. See the
following reference and reattach the media
holding plates.
"Loading and Exchanging Media" on
U
page 26
If installing the media holding plate correctly still
does not resolve the problem, perform the
following measure.
C
Feed Adjustment
Feed adjustment may be required independently
depending on the media used. If the roll width is
different, independent adjustment is required
even with the same media. For more accurate
adjustment, print a test pattern using the
following settings: Manual - 500mm Pattern.
"Feed Adjustment" on page 49
U
Stains Due to Head Striking
The media and print head are contacting during
printing.
Perform the following sequence until the print results
have improved.
A
Cut sections of media with wrinkles or waviness
If media is stored inappropriately or left loaded
in the printer, wrinkles and waviness may occur.
If media is used in this state, the print head and
the raised surface of the media may contact and
cause staining. Cut sections with wrinkles or
waviness before using media.
Problem Solver
Furthermore, store media as described in the
manual accompanying the printer and load
media in the printer just before printing.
If the problem is not resolved even when printing
on sections without wrinkles or waviness,
perform the following measure.
B
Loading the media in the printer correctly and
configuring the media settings appropriately
If the media loading method, Heater
Temperature, tension, Media Suction and other
settings are inappropriate, wrinkles and waviness
occur on the media. Make sure the loading
method and settings are correct.
"Loading and Exchanging Media" on
U
page 26
If the measures above do not resolve the problem,
perform the following measure.
C
Checking that the media is loaded correctly in the
Auto Take-up Reel Unit
If the method to attach the media to the take up
roll core is inappropriate, media may move
around during take-up, which may cause
wrinkles and raised sections.
Make sure media is being loaded on the Auto
Take-up Reel Unit correctly.
"Using the Auto Take-up Reel Unit" on
U
page 35
D
Set the after heater temperature correctly.
Adjust the after heater temperature to suit the

media.

Media
Media Is Creased
Are the Feeding Tension and Feed Speed
o
options in the setup menu correct for the
current media?
If these options are not correctly adjusted for the
current media, the media may be creased or torn
during printing.
"Feeding Tension" on page 46
U
"Feed Speed" on page 47
U
107