Epson SC-F9200 series User Manual page 9

SC-F9200 Series User's Guide
E
Roll core holder
Place the used roll core for media take-up on these holders. There are two supports: one on the left and one on the
right.
"Media Loading" on page 35
U
F
Roll core holder locking screw
The locking screws keep the roll core holders in place once they have been attached to the roll core. There are two
supports: one on the left and one on the right.
G
Roll support
Rest media temporarily on these supports when removing the take-up roll. There are two supports: one on the left
and one on the right.
H
Auto switch
Use this switch to select the auto take-up direction. Choose off to disable auto take-up.
I
Manual switch
Use this switch to select the manual take-up direction. The selected option takes effect when the Auto switch is in
the off position.
J
Adjustment screw
Use the adjustment screw when performing parallel adjustment.
K
Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the
printer is in use.
If the stand fixing screw is lowered too much, the caster rises off the floor. Do not use the printer when a caster is off
the floor.
L
Airflow vents
Allows air to flow into the printer. Do not obstruct these vents.
M
Waste Ink Bottle holder
Place the Waste Ink Bottle in this holder.
N
Stand fixing screw
There are two screws on each leg. In addition to locking the casters, the stand fixing screws also keep the printer
securely in place. After installing the printer, keep it securely in place during use.
O
Waste Ink Bottle
Waste ink collects in this bottle.
Replace with a new Waste Ink Bottle when the level approaches the line.
P
Stopper
The stopper prevents splatter when the waste ink is ejected.
Fit the stopper closely to the mouth of the Waste Ink Bottle in most situations.
Q
Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the Waste Ink Bottle while the printer is in
use.
Introduction
9