Epson SC-F9200 series User Manual page 29

SC-F9200 Series User's Guide
c
Important:
If the roll holder is inserted into the roll core
insufficiently, media is not fed correctly during
printing because of slippage between the roll
holder and roll core.
This may cause banding in the print results.
K
Tighten the roll holder fixing screw until the
screw no longer turns to fix the roll holder in
place.
c
Important:
If the roll holder fixing screw is loose, the roll
holder may move during printing. This could
cause stripes and unevenness in the print
results.
Basic Operations
L
Rotate the handle until part A in the illustration
below is fully inserted.
c
Important:
Once part A is hidden, do not turn the handle
any further. Failure to observe this precaution
could damage the roll holder.
If part A is still visible even after the handle has
been turned fully, rewind the handle. Loosen
the roll holder fixing screw on the right side,
and then restart from Step 9.
M
Confirm that the right and left edges of the
attached roll are aligned.
If the right and left edges of the roll are not
aligned, realign them.
N
Raise the media loading lever.
29