Printable Area - Epson SC-F9200 series User Manual

SC-F9200 Series User's Guide

Printable area

The gray area in the illustration below shows the printable area. The arrow indicates the feed direction.
The left and right edges of media recognized by the printer varies as shown below according to the Media Size
Check settings.
: The printer automatically detects the left and right edges of the loaded media.
On
When media holding plates are attached, within 5mm of the left and right edges of the media is
recognized as the media edge.
The edges of the media are not detected correctly if the media holding plates are not attached correctly.
"Loading media" on page 26
U
Off : The longest scale on the after heater's label (in the illustration below) is used as the standard position for
the right edge of the media. Regardless of the width of the loaded media, the left edge of the media is
determined to be 1,626 mm (64 inches) from the standard position for the right edge.
* When Media Size Check is set to Off, this is 1,626 mm (64 inches) regardless of the width of the loaded media.
Basic Operations
53