Epson SC-F9200 series User Manual page 45

SC-F9200 Series User's Guide
Heating & Drying
Set the temperature of the after heater or Drying Time
Per Pass.
Note:
Adjust Heater Temperature as follows:
❏ Set the heater to the temperatures recommended in
the documentation provided with the media, if
available.
❏ Raise the temperature if the print results are blurred
or smudged or the ink clots. Note, however, that
raising the temperature too high can cause the
media to shrink, wrinkle, or deteriorate.
A
Use the d/u buttons to select Heating & Drying
and press the Z button.
B
Use the d/u buttons to select the item you want
to change.
Heater Temperature
(1) Select Heater Temperature and press the Z
button.
(2) Use the d/u buttons to set the after heater
temperature.
Drying Time Per Pass
(1) Use the d/u buttons to select Drying Time Per
Pass and press the Z button.
(2) Use the d/u buttons to set the drying time.
When you want to maintain a constant drying
time even when the print width changes, set the
following value in accordance with the media
width.
Drying Time Guidelines by Media Width
Media width
64 in
52 in
44 in
42 in
36 in
Basic Operations
Drying time (seconds)
2.3
2.0
1.8
1.7
1.6
45
Media width
24 in
Blank Area Feed
(1) Use the d/u buttons to select Blank Area Feed
and press the Z button.
(2) Use the d/u buttons to select the desired setting.
The following section shows the recommended
setting values for Blank Area Feed according to
the number of passes.
Recommended setting values for Blank Area
Feed
Number of
passes
1 to 3
4
6 to 8
After Heater Feed
(1) Use the d/u buttons to select After Heater Feed
and press the Z button.
(2) Use the d/u buttons to select whether to feed
media to the after heater after printing (On/Off).
C
After finishing the configuration, press the Z
button.
D
Press the y button twice to return to the
customize settings menu.
Media Suction
While printing, the printer uses suction to maintain the
correct distance between the media and the print head;
the amount varies with the type of media. Less suction is
used for thin media that would not print or feed
correctly at high levels of suction.
The suction power is weakened when the parameter is
lowered.
A
Use the d/u buttons to select Media Suction and
press the Z button.
Drying time (seconds)
1.3
Blank Area Feed
Mode 1
Mode 2
Mode 3