Epson SC-F9200 series User Manual page 127

SC-F9200 Series User's Guide
P
At the front and rear of the printer, raise film a
and move it so that it aligns with the right side of
film b tightly. After film a stops swinging, check
the scale at the edge of the plate on the platen and
on film a.
If the value is different from the left side, proceed
to Step 17. If the value is the same, proceed to Step
20.
Q
Use the small hexagon wrench to loosen the 2
screws.
Appendix
R
While checking the scale of film a on the front
side of the printer, make adjustments using the
large hexagon wrench while you use your hand to
hold the media guide bar.
If the adjustment screw is turned
counterclockwise, the scale moves back. If the
adjustment screw is turned clockwise, the scale
moves towards you. One turn of the screw moves
the line about 1 mm. If the value of this scale
matches the left side, the adjustment is complete.
S
Use the small hexagon wrench to tighten the 2
screws.
127