Epson SC-F9200 series User Manual page 50

SC-F9200 Series User's Guide
❏ Enter a correction during printing and inspect the
results.
"Changing settings during printing" on
U
page 51
Notes on correct adjustment
The condition of media is important for correct Feed
Adjustment.
Observe the following points when loading media.
❏ Feed Adjustment varies with the media used. Load
the media for which feed adjustment is required
under the same conditions as the actual print job.
For example, if you are using the Auto Take-up Reel
Unit for printing, the Auto Take-up Reel Unit
should also be used for feed adjustment.
❏ We recommend performing adjustment again in
the following cases, even if the media has been
adjusted.
❏ When the media type is the same but the width
is different.
❏ When Feeding Tension or Take-up Tension
have been changed.
❏ When Media Suction has been changed.
❏ When spacer is attached.
❏ Pull the media to the prescribed position before
performing Feed Adjustment. Correct adjustment
may not be possible if the media is not pulled
sufficiently because the condition of the leading
edge of the media may worsen due to waves or other
issues.
Loading MediaU "Loading and Exchanging
Media" on page 26
Basic Operations
Setting procedure
Buttons that are used in the following settings
A
Confirm that the media has been pulled to the
prescribed position.
Correct adjustment may not be possible if the
media is not pulled sufficiently.
Loading MediaU
Media" on page 26
B
After confirming that the printer is ready, press
the Menu button.
The settings menu will be displayed.
C
Select Media Setup and press the Z button.
D
Use the d/u buttons to select Customize
Settings and press the Z button.
E
Use the d/u buttons to select a media setting
bank number between 1 and 30 and then press
the Z button.
Note that any settings already saved in the printer
will be overwritten.
F
Use the d/u buttons to select Feed Adjustment
and press the Z button.
G
Select Manual and press the Z button.
H
Use the d/u buttons to select a test pattern and
press the Z button twice.
The longer the pattern, the more accurate the
adjustment.
50
"Loading and Exchanging