Epson SC-F9200 series User Manual page 40

SC-F9200 Series User's Guide
Take-up with the Printed Side Facing
Out
A
Pass the media through the front side of the
media guide bar, and then attach the media to the
take up roll core with tape.
In the order shown in the illustration, tape the
media to the take up roll core. When attaching in
the center, attach using tape while pulling the
center of the media straight. When attaching on
the left and right, attach using tape while pulling
the media sideways.
c
Important:
If the media is lifted up between the attached
pieces of tape, the media will not be taken up
correctly. If the media is lifted up, we
recommend either adding tape and attaching
it uniformly or fixing creases at the leading
edge of the media.
Basic Operations
B
Press the d button in the control panel to feed
enough media for a single wrap around the roll
core.
C
Check that the Auto switch is set to off, and then
hold down the Manual switch on the
to wind the media that was fed in step 2 around
the roll core.
40
side