Table of Contents
Advertisement
Number
Name
Preview (Preview)
6
7
Material name
Play type (Play)
8
Play start date
9
(Date)
Play start time
0
(Start)
Play end time
qa
(End)
Play duration
qs
(Duration)
Play delay (Delay)
qd
Play start position
qf
(Position)
Information displayed
Selects whether material is previewed and, if Preview is
set, selects a port.
Off: The material is not previewed.
P1
P2
P3
Displayed when no material is being recorded.
Selects the play type from the following:
Off: The material is not played.
1 Time: The material is played once.
Daily: The set play is performed daily.
Weekly: The set play is performed weekly.
Selects the play port.
P1
P2
P3
Selects the play trigger.
Auto: The control panel performs both standby and play
commands.
Manual: The control panel performs a standby
command, but does not issue a play command. Use this
when you want to issue record commands from a GPI or
9-pin remote.
Delay: Effective when the recording trigger is set to
Manual. The control panel performs a standby or play
command for the delay specified for recording.
When the play type is 1 Time:
Sets the play start date.
When the play type is Weekly:
Sets the play start day.
Sets the play start time. (hh:mm:ss)
Sets the play end time. (hh:mm:ss)
Sets the play duration. (hh:mm:ss)
Sets an play delay. (hh:mm:ss) The shortest delay
between recording and play events on the same Cue
Sheet is 5 seconds.
Sets the material play start position (TM2). To switch
between Auto and Manual, press the B5 key while
pressing the SHIFT key.
Auto (hh:mm:ss:ff): Sets the play start position time
code.
Manual: Allows to set the play start position manually
during JOG, VAR, and SHUTTLE playback. (Cannot be
performed during playback initiated with the PLAY
button.)
Chapter 3 Operating Modes
3-55 (E)
Advertisement
Table of Contents
