Table of Contents
Advertisement
To leave recorder edit mode and return to normal edit mode
6-8-2 Performing Voice-over Editing
In the Recorder Edit mode, hold down the RECORDER button and then press
the EDIT button to return to the normal Edit mode. You can also just press the
PLAYER button to return to the normal Edit mode.
With this unit you can add audio and perform video voice-over editing. Before
you perform voice-over editing, note the following points.
• Before executing AUTO EDIT, you must execute PREVIEW. After
PREVIEW, if the edit points or edit channel have changed, you must execute
PREVIEW once again.
• In the Insert mode, INS (Insert) cannot be set.
1
PB EE
TRIM
L1
L2
IN
OUT
L3
AUDIO
L4
ENTRY
L5
L6
IN
OUT
L7
L8
L9
DMC EDIT
DELETE
L10
MEMORY
L1 1
PREVIEW
AUTO EDIT
REVIEW
B1
MODE
SHIFT
2
4
Follow the procedure below to perform voice-over editing of a material
opened in the Recorder Edit mode.
1
Specify the edit points (IN and OUT point) and the channel where you
want to perform voice-over editing.
Note
The IN point must be set within one frame of the end of the destination
material.
For details about how to set edit points, see Section 6-2-6, "Setting the Edit
Points" (page 6-8).
2
As the PREVIEW button is flashing, you can execute PREVIEW. At this
time the input signal for the interval between the IN and OUT points is
recorded.
3
When PREVIEW is completed and the PREVIEW and AUTO EDIT
buttons flash, you can execute AUTO EDIT.
4
Press the AUTO EDIT button to execute editing.
When you execute editing, the material recorded in step 2 is inserted with
OVL (overlay) in the interval between the IN and OUT points.
PB
HOLD
RESET
TC/UB
TIMER SEL
1
EXT
2
MULTI
CONTROL
PREROLL
REW
B2
B3
B4
B5
B6
B7
Chapter 6 Editing
SHUTTLE
JOG
VAR
R1
P1
PORT SELECT
R2/
R3/
P3
P2
PLAYER
RECORDER
REC
EDIT
PLAY
F. FWD
STOP
6-35 (E)
Advertisement
Table of Contents
