Yamaha 2012 Grizzly 300 Service Manual page 107

1
CHECKING THE TIRES
1. Measure:
• tire pressure
Out of specification → Adjust.
TIP
• The low-pressure tire gauge
standard equipment.
• If dust or the like is stuck to this gauge, it will
not provide the correct readings. Therefore,
take two measurements of the tire's pressure
and use the second reading.
Cold tire
pressure
Standard
Minimum
Maximum
WARNING
Uneven or improper tire pressure may
adversely affect the handling of this
machine and may cause loss of control.
• Maintain proper tire pressures.
• Set tire pressures when the tires are cold.
• Tire pressures must be equal in both front
tires and equal in both rear tires.
2. Check:
• tire surfaces
Wear/damage → Replace.
Tire wear limit
a
WARNING
It is dangerous to ride with a worn-out tire.
When tire wear is out of specification,
replace the tire immediately.
3-49
CHK
ADJ
is included as
Front
30.0 kPa 25.0 kPa
(0.300 kgf/cm², (0.250 kgf/cm²,
4.4 psi) 3.6 psi)
27.0 kPa 22.0 kPa
(0.270 kgf/cm², (0.220 kgf/cm²,
4.0 psi) 3.2 psi)
33.0 kPa 28.0 kPa
(0.330 kgf/cm², (0.280 kgf/cm²,
4.8 psi) 4.1 psi)
Front and rear: 3.0 mm (0.12 in)
Rear