High Beam Indicator Light; Low Coolant Temperature Indicator Light - Yamaha FX10B Owner's Manual

Control functions
Odometer, tripmeter, and engine
speed meter modes
1. Odometer/tripmeter/engine speed meter
Pushing the "SELECT" button switches the
display between the odometer mode "ODO",
tripmeter mode "TRIP", and engine speed
meter mode "r/min" in the following order:
ODO → TRIP → r/min → ODO
To reset the tripmeter, push the "RESET" but-
ton for at least 1 second while the tripmeter is
displayed.
TIP
To switch the speedometer, odometer, and
G
tripmeter displays between kilometers and
miles, select the odometer mode "ODO",
and then push the "SELECT" button for at
least 10 seconds while the snowmobile is
stopped.
Use the engine speed meter only when
G
checking the snowmobile and performing
basic maintenance. The engine speed
meter should not be used while riding the
snowmobile since the reading will vary from
the actual engine speed.
ESU10411

High beam indicator light "

The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 15 for headlight beam switch
operation.)
12
1
1. High beam indicator light "
ESU10473
Low coolant temperature indi-
cator light "
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
The snowmobile can be operated normally af-
ter the indicator light goes off.
1. Low coolant temperature indicator
light "
TIP
Drive the snowmobile at low speeds when the
"
low coolant temperature indicator light is on. If
the engine speed is too high, maximum en-
gine speed is reduced to protect the engine.
"
"
"