Adjusting The Rear Pedal Position - Yamaha 2012 Grizzly 300 Service Manual

ADJUSTING THE REAR PEDAL POSITION

a
2
a
1
ADJUSTING THE REAR PEDAL POSITION
1. Measure:
• rear brake pedal height
Out of specification →
Rear brake pedal height
47.0–57.0 mm (1.85–2.24 in)
2. Remove:
• seat
• right side cover
• right footboard
Refer to "SEAT, SIDE COVERS AND
FOOTREST BOARDS".
3. Adjust:
• rear brake pedal height
a. Loosen the locknut
b. Turn the adjusting bolt
pedal height is within the specified limits.
c. Tighten the locknut.
TIP
When adjusting the brake pedal height make
sure the locknut-to-adjusting bolt clearance
does not exceed 8 mm (0.31 in).
WARNING
After this adjustment is performed, lift the
front and rear wheels off the ground by
placing a block under the engine, and spin
the rear wheels to ensure there is no brake
drag. If any brake drag is noticed, perform
the above steps again.
4. Install:
• right footboard
• right side cover
• seat
Refer to "SEAT, SIDE COVERS AND
FOOTREST BOARDS".
3-32
CHK
ADJ
a
Adjust.
.
1
until the brake
2
a