REAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT
3
1
2
1
1
2
REMOVING THE FINAL DRIVE ROLLER
BEARING
1.Remove:
2
•
Oil seal
•
Roller bearing (ring gear)
Use a suitable press tool
priate support for the main housing.
2.Remove:
•
Roller bearing (final drive pinion gear)
Removal steps:
•
Heat the main housing only to 150 ˚C
(302 ˚F).
•
Remove the roller bearing outer race with
an appropriately shaped punch
•
Remove the inner race from the final drive
pinion gear.
TIP
The removal of the final drive pinion gear
roller bearing is difficult and seldom neces-
sary.
ASSEMBLING THE FINAL DRIVE ROLLER
BEARING
1.Install:
3
•
Roller bearing (final drive pinion gear)
Installation steps:
•
Heat the main housing only to 150 ˚C
(302 ˚F).
•
Install the roller bearing outer race using
the proper adapter.
•
Install the inner race onto the drive pinion
gear.
2.Install:
•
Oil seal
•
Roller bearing
Use a suitable press tool
install the above components into the
main housing.
7-5
DRIV
1
2
and an appro-
3
2
1
New
2
3
and a press to
1
.
New