Yamaha 2012 Grizzly 300 Service Manual page 258

1
2
8-39
STEERING SYSTEM
REMOVING THE TIE-RODS
The following procedure applies to both of the
tie-rods.
1. Remove:
• tie-rod
TIP
When removing the tie-rod, hold each tie-rod
ball joint with a 14-mm wrench
loosen the tie-rod end nut.
REMOVING THE STEERING KNUCKLES
The following procedure applies to both of the
steering knuckles.
1. Remove:
• steering knuckles
TIP
• Attatch the ball joint remover/attatchment
set/short set and new ball joint (with rubber
boot and retaining ring) "7" to the steering
knuckle "8".
• Always use a new ball joint set.
Do not tap or damage the top of the ball
•
joint.
Ball joint remover
90890-01474
Ball joint remover attatchment set
90890-01480
Ball joint adapter set
YM-01480
Ball joint remover short shaft set
90890-01514
YM-01514
Body
9
10 Installer spacer
11 Installer washer
12 Base
13 Guide bolt
14 Short bolt
CHAS
and then
90890-01474
YM-01474
90890-01480
YM-01480
90890-01514
YM-01514