Table of Contents
Advertisement
2.
Push the "RESET" button to change the
hour setting, and then push the "SE-
LECT" button. The minute digits will start
flashing.
3.
Push the "RESET" button to change the
minute setting, and then push the "SE-
LECT" button. The clock starts when the
"SELECT" button is released.
TIP
The clock must be set again when the battery
is disconnected.
Display brightness control
This function allows you to adjust the bright-
ness of the meter display to suit the outdoor
lighting conditions.
To adjust the display brightness
1.
Turn the key to the off position.
2.
Push and hold down the "SELECT" but-
ton.
1
2
1. "SELECT" button
2. "RESET" button
3. Display brightness level
3.
Turn the key to the on position, and then,
after 5 seconds, release the "SELECT"
button.
4.
Push the "RESET" button to select the
desired display brightness level, and then
push the "SELECT" button. The normal
display returns when the "SELECT" but-
ton is released.
ESU10411
High beam indicator light "
The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 20 for headlight beam switch
operation.)
1. High beam indicator light "
ESU10473
Low coolant temperature indi-
cator light "
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
The snowmobile can be operated normally af-
ter the indicator light goes off.
3
1. Low coolant temperature indicator
Control functions
"
light "
"
"
"
15
Advertisement
Table of Contents
