Yamaha 2012 Grizzly 300 Service Manual page 244

1
2
b
FRONT AND REAR BRAKES
INSTALLING THE FRONT BRAKE MASTER
CYLINDER
1. Install:
• brake master cylinder
• parking brake lever
TIP
• The parking brake lever installing, please refer to
"INSTALLING THE PARKING BRAKE LEVER".
• Install the brake master cylinder so that the
gaps between the brake master cylinder and
the parking brake lever are equal.
2. Install:
1
• copper washers
• brake hose
a
2
• union bolt
NOTICE
When installing the brake hose onto the
brake master cylinder, make sure the brake
pipe
shown.
TIP
• Tighten the union bolt while holding the brake
hose as shown.
• Turn the handlebar to the left and to the right
to check that the brake hose does not touch
other parts (throttle cable, wire harness,
leads, etc.). Correct if necessary.
Proper brake hose routing is essential to
insure safe machine operation. Refer to
"CABLE ROUTING" in chapter 2.
8-25
CHAS
1
2
Brake master cylinder holder bolt
13 Nm (1.3 m•kg, 9.4 ft•lb)
2
1
Union bolt
28 Nm (2.8 m•kg, 20.3 ft•lb)
touches the projection
a
WARNING
as
b