Checking The Coolant Level - Yamaha 2012 Grizzly 300 Service Manual

CHECKING THE COOLANT LEVEL/

b
a
1
CHANGING THE COOLANT
CHECKING THE COOLANT LEVEL
1. Place the machine on a level surface.
2. Check:
• Coolant level
The coolant level should be between the
minimum level mark
mark .
b
Below the minimum level mark → Add the
recommended coolant to the proper level.
NOTICE
• Adding water instead of coolant lowers
the antifreeze content of the coolant. If
water is used instead of coolant, check
and if necessary, correct the antifreeze
concentration of the coolant.
• Use only distilled water. However, soft
water may be used if distilled water is not
available.
3 . Start the engine, warm it up for several
minutes, and then turn it off.
4. Check:
• Coolant level
TIP
Before checking the coolant level, wait a few
minutes until the coolant has settled.
CHANGING THE COOLANT
1 . Remove:
• front carrier
• front panel
Refer to "FRONT CARRIER, FRONT BUMPER
AND FRONT FENDER".
2 . Disconnect:
• coolant reservoir hose
3 . Drain:
• Coolant
(from the coolant reservoir)
4 . Connect:
• coolant reservoir hose
3-25
CHK
ADJ
and maximum level
a
1