Checking The Coolant Level - Yamaha 2004 YXR660 Service Manual

CLEANING THE AIR FILTER/

CHECKING THE COOLANT LEVEL

c. Apply Yamaha foam air filter oil or other
d. Squeeze out the excess oil.
NOTE:
The element should be wet but not dripping.
L
6. Install:
NOTE:
To prevent air leaks make sure that the sealing
surface of the element matches the sealing
surface of the case.
7. Install:
CHECKING THE COOLANT LEVEL
1. Place the vehicle on a level surface.
2. Lift the hood up.
3. Check:
• Adding water instead of coolant lowers
• Use only distilled water. However, soft
3 - 18
quality foam air filter oil.
LLL L LLL L L LLL L L LLL L
• air filter element
• air filter case cover
• console
• passenger seat
• driver seat
Refer to "SEATS, ENCLOSURE, HOOD
AND CARGO BED" in chapter 8.
• coolant level
The coolant level should be between the
minimum level mark a and maximum level
mark b.
Below the minimum level mark → Add the
recommended coolant to the proper level.
CAUTION:
the antifreeze content of the coolant. If
water is used instead of coolant, check
and if necessary, correct the antifreeze
concentration of the coolant.
water may be used if distilled water is not
available.
CHK
ADJ
L LLL L L LLL L LLL