Functions Of Linkage Menu - FUTABA T18MZ WC Instruction Manual

The Linkage Menu has all of the functions you
will need to perform model addition, model type
selection, frequency setting, end point setting, and
other model basic settings.
Servo Monitor : Displays the servo test and operation position
Model Select : Model addition, call, deletion, copy, model name setting
Model Type : Model type, wing type, switch type, etc. selection
Picture : Picture selection and setting for each model
Sound : Sound recording and playback
System Type : System selection, receiver link, telemetry.
Function : Channel assignment of each function can be changed
Sub-Trim : Adjusts the neutral position of each servo
Servo Reverse : Servo direction reversal
Fail Safe : Fail safe function and battery fail safe function setting
End Point (ATV) : Servo basic rudder adjustment and limit setting
Throttle Cut : Stops the engine safely and easily (airplane and helicopter only)
Idle Down : Lowers the idle speed of the engine (airplane and helicopter only)
Swash Ring : Limits the swash travel within a xed range to prevent linkage damage (helicopter only)
Swash : Swash AFR and linkage correction function (helicopter only)
Timer : Timer setting and lap time display
Dial Monitor : Dial, slider, and digital trim position display and setting
Function Name : Function Name can be changed
Telemetry : Displays various data sent from the receiver
Sensor : Various telemetry sensors setting
Sensor Name : Change of a sensor name
Telemetry Setting : Data logging of telemetry
Warning : Warning sound and vibration setting
Data Reset : Model memory data reset (by various item)
70
＜ Linkage Menu ＞
The functions which can be selected depend on
which model type you are using. A typical menu
screen is shown below.
Condition Hold function ON/OFF button