Afr (D/R) - FUTABA T18MZ WC Instruction Manual

AFR function is used to adjust the throw and
operation curve of the stick, lever, and switch
functions (CH1 to CH16) for each ight condition.
This is normally used after End Point (ATV) has
defined the maximum throw directions (End Point
acts on ALL ight condition settings). When mixing
is applied from one channel to another channel,
both channels can be adjusted at the same time
by adjusting the operation rate through the AFR
function.
the setup screen shown below.
1. When the function select button is touched, a selection screen appears.
set in the currently
selected condition)
(For a description of the setting
method, see the description at
118
＜ Model Menu (Common Functions) ＞
can be used for the line and spline curve
points can also be increased and decreased
and curves from complex curves to simple
curves can be used.
speed of each function when the function
is operated (including at flight condition
switching) can be adjusted. The function
operates smoothly at a constant speed
corresponding to the set speed.
(Currently selected condition name)
(For a description of the setting method, see the
When setting the D/R function, the screen display mode
can be changed. Each time the button is touched, the mode
is switched.
curve is displayed.
condition are displayed.
displayed.