To Turn On/Off The Power Of The Transmitter; How To Stop The Transmitter; Basic Operation - FUTABA T18MZ WC Instruction Manual

®
Windows CE is installed as a built-in operating
system in the T18MZ-WC transmitter. Compared to
the conventional system, the T18MZ-WC takes extra
time for internal processing when it is turned on/off.
When turning on the power of the transmitter
1. Place the throttle stick below 1/3 closed.
2. Turn on the power switch.
*After initialization of the transmitter is complete, the
LED monitor turns Purple.
*If your throttle stick is not at 1/3 closed or fully
closed, a warning will sound. If you move the
throttle to 1/3 closed or fully closed, the warning will
stop and will become a "Transmit ?" screen.
*If you push the button "NO", then the transmitter will
not emit radio waves.
*If you push the button "Yes", then the transmitter will
emit radio waves.
*If a battery is removed and it re-connects, please
switch on a power supply, after 3 seconds or more
pass.
Start-up time;
The time required to initialize the internal circuit
of the transmitter varies between the previous time
you turned the power off and then restarted the
transmitter. There are two "start up" modes for your
transmitter, see below:
Cold start;
If you turn on the transmitter more than four hours
after you last turned it off, the mode is "Cold start".
"Cold start" is normal for the rst initial power up of
the day. It will take about 30 seconds to be ready for
use, as it takes time to initialize the internal circuit of
the transmitter.
Hot start;
If you turn on the transmitter less than four hours
after you last turned it off, the mode is "Hot start".
Since initialization has been partly completed, the
transmitter will be ready to use in several seconds.
36
＜ Basic Operation ＞
"Hot start" takes place usually at a second ight or
later ight in the day.
WARNING
Once you turn on the power, never shut off the
power switch until the power becomes stable (or
until the first screen shows up). If you turn off
the power switch while the transmitter is going
through the initialization process, the data could
be damaged.
Note: The start-up time may be a little bit
slower when the SD card is installed compared
to when the card is not.

How to stop the transmitter

Turn off the power switch of the transmitter. The
internal circuit of the transmitter starts the shut down
process including saving the set-up data.
or
Once you turn off the power, never operate the
power switch until the power shutdown process
is fully completed. If you turn on the power
switch again while the transmitter is still in the
process of power shutdown, the data could be
damaged.