S.bus Installation - FUTABA T18MZ WC Instruction Manual

This set uses the S.BUS system. The wiring is as simpli ed and clean mounting as possible, even with models
that use a large number of servos. In addition, the wings can be quickly installed to the fuselage without any
erroneous wiring by the use of only one simple wire, even when there are a large number of servos used.
When using S.BUS, special settings and mixes in your transmitter may be unnecessary.
The S.BUS servos and S.BUS gyros memorize the number of channels themselves. (Settable with the T18MZ-
WC)
The S.BUS system and conventional system (receiver conventional CH used) can be mixed.
S.BUS Glider usage example
S.BUS Aerobatic plane usage example
HUB ( Optional )
i-Connector ( Optional )
Receiver: R7008SB
Servo: S3173SVi×9(Optional )
Throttle servo: BLS173SV ( Optional )
Battery: FR2F1800 ( Optional )
Switch: ESW-1J
Receiver: R7008SB
Aileron servo: BLS174SV×2 ( Optional )
HUB×3 ( Optional )
Rudder Servo: BLS175SV×1 ( Optional )
Elevator servo: BLS173SV×2 ( Optional )
＜ Before Use ＞
31