Receiver Ch Mode - FUTABA T18MZ WC Instruction Manual

DANGER
Don't connect neither a switch
nor a battery in this way.
* It will short-circuit, if it connects in this way.
A short circuit across the battery terminals may
cause abnormal heating, fire and burns.
R7008SB CH Mode
The R7008SB receiver is a very versatile unit. It
has 8 PWM outputs, S.BUS and S.BUS2 outputs.
Additionally the PWM outputs can be changed from
channels 1-8 to channels 9-16. If you only desire to
use it as an 8 channel receiver (without S.BUS), it
can be used without any setting changes.
The T18MZ-WC has the ability to link to two
R7008SB receivers - one of them outputting
channels 1-8 and the other outputting channels 9-16,
giving you 16 PWM channels. Instructions for this
con guration and S.BUS operation follow.
Receiver
connector
1
2
3
4
5
6
7/B
8/SB
Red LED blink
Mode A Mode B
1 ∼ 8CH 1 ∼ 7CH
1
2
3
4
5
6
7
8 S.BUS
1 time 2 times
Default
[How to change the R7008SB Channel mode.
1. Press and hold down the Link/Mode button on
the R7008SB receiver.
2. Turn the receiver on while holding down the
Link/Mode button. When the LED begins to
blink green/red the button may be released.
3. The LED should now be blinking red in one of
the patterns described by the chart below.
4. Each press of the Mode/Link button advances
the receiver to the next mode.
5. When you reach the mode that you wish to
operate in, press and hold the Mode/Link
button for more than 2 seconds.
6. Once locked into the correct mode the LED
will change to a solid color.
7. Please cycle the receiver(s) power off and
back on again after changing the Channel
Mode.
Setting channel
Mode C
9 ∼ 16CH
1 9
2 10
3 11
4 12
5 13
6 14
7 15
16
3 times
Mode D
9 ∼ 15CH
9
10
11
12
13
14
15
S.BUS
4 times
＜ Before Use ＞
27