FUTABA T18MZ WC Instruction Manual page 125

18 channel computer system
Table of Contents

Advertisement

This mixing is used when you want to the mix
camber flaps with elevator operation. Lift can be
increased with raised elevators.
[Airplane/glider, 2 ailerons or more]
This mixing is used to correct for attitude changes
when the camber aps are being used.
[Airplane/glider, 2 ailerons + 1 ap or more]
This function is used when powerful brake
operation is necessary.
[Glider, 2 ailerons or more]
The ailerons, elevators, and flaps trim offset rate
can be utilized by a switch or condition selection.
[Glider, 2 ailerons or more]
This function is used when airbrakes are necessary
when landing or when diving during ight.
[Airplane, general]
This is dedicated mixing when a gyro is used.
[Airplane/glider, general]
This function adjusts the elevators and rudder of
V-tail models.
[Airplane/glider, V-tail speci cations]
AIL1
(Main Aileron)
AIL 3
(Chip Aileron)
ELEVATOR
(RUDDER 2)
FLP 4
FLP 3
(Brake Flap)
(Brake Flap)
FLP 1
(Camber Flap)
RUDDER
ELEVATOR 2
ELEVATOR
(AILERON 6)
(AILERON 5)
at AILEVATOR
V-TAIL
RUDDER
RUDDER 1
(ELEVATOR 2)
(
Winglet
at Flying wing
< Model Menu (Airplane/Glider Functions) >
This function adjusts the elevators and ailerons of
models with elevator speci cations.
[Airplane/glider, elevator speci cations]
This function adjusts the left and right rudders of
winglet models.
[Airplane/glider, winglet speci cations]
The operation speed when the motor of F5B and
other EP gliders is started by switch can be set.
[EP glider, general]
This function is used to correct roll maneuvers,
knife edge, etc. of stunt planes.
[Airplane, general]
This function selects the snap roll switch and
adjusts the steering angle of each rudder. Servo
speed can also be adjusted.
[Airplane general]
This function adjusts the throttles independently
when using a multi engine model. (Maximum 4
engines)
[Airplane, general]
Acceleration setting can be performed at elevator,
ELE to Camber and AIL to RUD.
[Glider/EP glider]
AIR BRAKE
FLP 2
(Camber Flap)
AIL 2
(Main Aileron)
AIL 4
(Chip Aileron)
at Flying wing
RUDDER 2
(
Winglet
at Flying wing
)
)
125

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents