1M23N26419
This software updates or alters the functions and features noted below. The instructions and information that follow are meant as a supplement to the original instruction
manual that accompanied the T18MZ transmitter. Please refer to the original instruction manual where applicable, but replace the steps indicated below with these
instructions. Please note that the software update will be finalized the first time that the T18MZ is powered up, after the software has been applied. As such, it may require a
few moments before the Start screen appears. Please check to ensure that the update has been installed.
1) Select the System Menu.
2) Touch the [Information] button.
3) Confirm that the information in the display indicates the Editor and Encoder version numbers as noted above.
4) If you would like to copy model data from a T18MZ-WC to a T18MZ, update the T18MZ to the latest software.
5) Even if you update not a T18MZ-WC but a T18MZ to the latest software, T-FHSS is still not available for the T18MZ.
6) If you copy model data whose system type is T-FHSS into a T18MZ, the system type of it will be converted to FASSTest automatically.
1. SBS-01C current sensor function
The T18MZ has been made compatible with the SBS-01C current sensor.
Current / Voltage / Capacity Display
The SBS-01C has the capability of measuring
current, voltage and capacity from drive battery at
the same time.
current
voltage
minimum after starting reception until
the transmitter is turned off.
capacity
T18MZ SOFTWARE UPDATE CHANGES
(Editor Version: 2.6 Encoder version: 2.3)
*Refer to the manual of SBS-01C for the details of wiring.
the alarm will operate
displayed on home 2
screen.
and minimum value
ranges. [Clear] to reset.
*Current sensor SBS-01C is required.
a numerical
value
voice alert in addition
to the alarm sound
when the alarm is
activated.