Model Menu (Common Functions) - FUTABA T18MZ WC Instruction Manual

This section describes the AFR, program mixing,
and other functions common to all model types.
Before setting the model data, use the Model Type
function of the Linkage Menu to select the model
type matched to the fuselage. When another model
type is selected thereafter, the AFR, program mixing,
and other setting data are reset.
The functions in the Model Menu can be set for each
ight condition. When you want to use the system by
switching the settings for each condition by switch,
stick position, etc., use the Condition Select function
to add ight conditions. (Up to 8 conditions can be
used)
Model Menu.
setup screen appears.
(Model Menu screen example)
*The Model Menu screen depends on the model type. This screen is for model type Airplane Wing Type 4AIL+4FLP.
Servo test and servo position display (For a
description of its functions, see the Linkage Menu
section.)
Flight conditions addition, deletion, copy, condition
renaming, and condition delay can be set.
Sets the rudder angle and curve of all the operation
functions. A D/R curve which can be switched with a
switch, etc. can also be added.
Note: The T18MZ-WC is designed so that the airplane
and glider (including EP glider) model types are
compatible with fuselages of similar type wings.
This section outlines the relationship between the
functions common to airplanes and gliders, except
some dedicated functions, and model type.
The setting items depend on the number of servos
and other differences according to the wing type
used, but reread them. The setup screens in the
instruction manual are typical examples.
Program mixing which can be freely customized. Up
to 10 mixes can be used for each condition.
Mixing used in needle adjustment of engines which
use a fuel mixture control carburetor. [Airplane,
helicopter]
＜ Model Menu (Common Functions) ＞
page
115