Servo Reverse - FUTABA T18MZ WC Instruction Manual

Servo Reverse changes the direction of an individual
servo's response to a control stick movement.
For CCPM helicopters, be sure to read the section
on Swash AFR before reversing any servos. With
CCPM helicopters, always complete your servo
reversing prior to any other programming. If you
use pre-built Airplane/Glider functions that control
multiple servos, it may be confusing to tell whether
the servo needs to be reversed or a setting in the
function needs to be reversed. See the instructions
for each specialized function for further details.
Servo reversing procedure
After setting up a new model, be sure to define all
special menus. Be sure that all servos are plugged
into the proper receiver channels. Now, determine
whether you need to reverse any channels by
moving each stick and observing the corresponding
movement in the model's controls.
84
＜ Linkage Menu ＞
Always check servo direction prior to every flight
as an additional precaution to con rm proper model
memory, hook ups, and radio function.
WARNING
Before a flight, always check that your models
servo operation, the direction of control surfaces,
and switch setup are correct.
Default setting of the motor channel is always
reverse.