Alert Messages - Ricoh C3030 Operating Instructions Manual

Troubleshooting When Using the Printer Function

Alert Messages

This section describes the machine alert messages.
Message
Cannot connect
with the wireless
card. Turn the
main power switch
off, then check
/
the card.
lems with the
wireless card.
Problems with the
4
wireless board.
Problems with
IEEE 1394 Board.
LProblem with
Hard Disk.
The entered
password is in-
correct.
USB has a problem.
Hardware Problem:
Ethernet
You do not have
the privileges to
use this function.
Authentication
has failed.
Parallel I/F
board has a
problem.
Printer font error.
50
• IEEE 802.11b interface unit
was not inserted when the
machine was turned on, or it
was pulled out after the ma-
chine turned on.
• The settings are not updated
Prob-
although the unit is detected,
or errors are found while ac-
/
cessing the unit.
An error may have occurred in
the IEEE 1394 board.
An error has occurred in the hard
disk drive.
The password of the encrypted
PDF file has been entered incor-
rectly.
An error has occurred in the USB
interface.
An error has occurred in the Eth-
ernet board.
Use of this function is restricted.
• The login user name or pass-
word entered is incorrect.
• The machine currently cannot
perform authentication.
An error has occurred in the par-
allel interface board.
An error has occurred in the font
settings.
Cause
Turn off the machine and check
the IEEE 802.11b interface unit is
inserted correctly. Then, turn the
machine on again. If the message
appears again, call your service
representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Enter the correct password.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Contact the administrator.
• Check your login user name
• Contact the administrator.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Contact your service representative.
Solution
and password.