Ricoh C3030 Operating Instructions Manual page 489

❒ When performing the auto color calibration from the printer function, se-
lect test patterns from [600 × 600 dpi], [1800 × 600 dpi] and [1800 × 600 dpi] and
then press [Start Printing].
❒ The test pattern will be printed on an A4K, 8
A4K is not available then A3 L, B4 JISL will be used.). Make sure to
check the paper set in the paper tray.
❒ Set the test pattern in the following way:
❒ When the ADF is installed, make sure to set the test pattern on the expo-
sure glass, and then 2 or 3 white sheets, same size as the test pattern, above
the test pattern.
Returning to the Previous Setting
"Previous Setting" means to return to the previous status before any changes.
A
Press [Previous Setting].
B
Press [Yes].
The settings return to the previous contents.
Note
❒ When returning the auto color calibration of the copy function, press [Pre-
vious Setting] of the Copier Function. If returning the auto color calibration
of the printer function, press [Previous Setting] of the Printer Function.
GCCLCPIE
Maintenance
1
/ "× 11"K size page (If
2
6
95