Alert Messages - Ricoh Aficio MP C2500 EFI Troubleshooting Manual

Troubleshooting When Using the Printer Function

Alert Messages

This section describes the machine alert messages.
Message
Cannot connect
with the wire-
less card. Turn
the main power
switch off, then
check the card.
Problems with
the wireless
/
card. Problems
4
with the wire-
less board.
Problems with
IEEE 1394 Board.
LProblem with
Hard Disk.
The entered
password is in-
correct.
USB has a prob-
lem.
Hardware Prob-
lem: Ethernet
You do not have
the privileges
to use this
function.
50
Cause
• IEEE 802.11b interface unit
was not inserted when the
machine was turned on, or it
was pulled out after the ma-
chine turned on.
• The settings are not updated
/
although the unit is detected,
or errors are found while ac-
cessing the unit.
An error may have occurred in
the IEEE 1394 board.
An error has occurred in the hard
disk drive.
The password of the encrypted
PDF file has been entered incor-
rectly.
An error has occurred in the USB
interface.
An error has occurred in the Eth-
ernet board.
Use of this function is restricted.
Solution
Turn off the machine and check
the IEEE 802.11b interface unit is
inserted correctly. Then, turn the
machine on again. If the message
appears again, call your service
representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Enter the correct password.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Turn off the main power switch,
and back on again. If the message
appears again, contact your serv-
ice representative.
Contact the administrator.