Ricoh C3030 Operating Instructions Manual page 415

Problem
Copies are too light.
Parts of images are not
copied.
Parts of images are not
copied.
Images appear only
partially colored.
Colored lines appear.
White lines appear.
White lines appear.
Copies are blank.
A moiré pattern is pro-
duced on copies.
Black spots appear on
the copy of a photo-
graphic print.
Cause
The paper is damp.
The original is not set correctly.
The correct paper size is not se-
lected.
The paper is damp.
The exposure glass or scanning
glass is dirty.
The exposure glass or scanning
glass is dirty.
When D is blinking, toner is be-
ginning to run out.
The original is not set correctly.
Your original has a dot pattern
image or many lines.
Because of high humidity, the
photographic print has stuck to
the exposure glass.
When You Cannot Make Clear Copies
Solution
Use paper that has been stored in
the recommended temperature
and humidity condition. See
"Copy Paper", About This Ma-
chine.
Set originals correctly. See "Plac-
ing Originals", Copy/Document
Server Reference.
Select the proper paper size.
Use paper that has been stored in
the recommended temperature
and humidity condition. See
"Copy Paper", About This Ma-
chine.
Clean them. See p.121 "Maintain-
ing Your Machine".
Clean them. See p.121 "Maintain-
ing Your Machine".
Add toner. See p.89 "Adding
Toner".
When using the exposure glass,
face the originals down. When
using the ADF, face them up.
Place the original on the exposure
glass at a slight angle.
Place the print on the exposure
glass in either of the following
ways:
• Place an OHP transparency
on the exposure glass, and
then place the print on top of
the OHP transparency.
• Place the print on the expo-
sure glass, and then place two
or three sheets of white paper
on top of it. Leave the expo-
sure glass cover or auto-docu-
ment feeder (ADF) open
when copying.
2
21