Ricoh C3030 Operating Instructions Manual page 139

❖ LAN Type
When you have installed the IEEE 802.11b interface unit, select the method of
connection.
• Ethernet
• IEEE 802.11b
[LAN Type] is displayed when wireless LAN board is installed. If Ethernet and
IEEE 802.11b (wireless LAN) are both connected, the selected interface has
priority.
❖ Ping Command
Check the network connection with ping command using given IPv4 address.
If you fail to connect to the network, check the following, and then retry the
ping command.
• Make sure that "IPv4" in [Effective Protocol] is set to "Effective".
• Check that the machine with assigned IPv4 address is connected to the net-
work.
• There is a possibility that same IPv4 address is used for the specified
equipment.
❖ Permit SNMPv3 Communication
Set the encrypted communication of SNMPv3.
• Encryption Only
• Encryption/Clear Text
If you select to [Encryption Only], you need to set an encryption password for
the machine.
❖ Permit SSL/TLS Communication
Set the encrypted communication of SSL/TLS.
• Ciphertext Only
• Ciphertext Priority
• Ciphertext/Clear Text
If you set to [Ciphertext Only], you need to install the SSL certificate for the ma-
chine.
❖ Host Name
Specify the host name.
Enter the host name using up to 63 characters.
❖ Machine Name
Specify the machine name.
Enter the machine name using up to 31 characters.
Interface Settings
2
61